ceilingtrains
#5
The parts are mig tacked together in special fixtures so the don't warp. I can make straight sections up to 5' long. The curves are for 72 inch track and are really big like hold your arms out 90 degrees apart. I have a male female connector where one side is male is welded and the female side has a lock screw. I weld a nub on the side rail, drill it then use my handy automatic Procuner tapper to bottom tap the 10-32 holes. It works great for that...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
ceilingtrains - by aametalmaster - 03-22-2012, 08:17 PM
RE: ceilingtrains - by DaveH - 03-22-2012, 08:22 PM
RE: ceilingtrains - by ETC57 - 03-22-2012, 09:13 PM
RE: ceilingtrains - by TOM REED - 03-22-2012, 10:25 PM
RE: ceilingtrains - by aametalmaster - 03-23-2012, 03:49 AM
RE: ceilingtrains - by DaveH - 03-23-2012, 04:11 AM
RE: ceilingtrains - by krv3000 - 03-23-2012, 03:25 PM
RE: ceilingtrains - by doubleboost - 03-24-2012, 05:42 PM



Users browsing this thread: 1 Guest(s)