12-02-2012, 03:13 PM
Here is a bearing splitter i made today from some 1" thick 4"x4" hot rolled steel. Just drilled a 3/4" hole in the center and cut a dish with the lathe. Then cut in half and deburred. Worked great. Even painted it with some of my seceret clear lacquer. Then i made a place to keep all of my 1" dia tooling from some angle with 1" holes punched in it. Waiting for that clear to dry to stick my tooling in...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...