|
Poor Man's Power Drawbar
|
 (12-01-2012, 08:27 PM)TomG Wrote: One of the plates mounts to the top of the mill with existing holes, and the other attaches to the impact wrench with the screws that hold the valve body on. That's half the battle right there, having the holes already in place. I wasn't so lucky. Looks good as usual Tom. 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Poor Man's Power Drawbar - by TomG - 12-01-2012, 08:27 PM
RE: Poor Man's Power Drawbar - by Mayhem - 12-01-2012, 08:57 PM
RE: Poor Man's Power Drawbar - by Rickabilly - 12-01-2012, 09:01 PM
RE: Poor Man's Power Drawbar - by EdK - 12-01-2012, 09:06 PM
RE: Poor Man's Power Drawbar - by sasquatch - 12-01-2012, 09:08 PM
RE: Poor Man's Power Drawbar - by Rickabilly - 12-01-2012, 09:22 PM
RE: Poor Man's Power Drawbar - by Highpower - 12-01-2012, 09:43 PM
RE: Poor Man's Power Drawbar - by TomG - 12-01-2012, 11:22 PM
RE: Poor Man's Power Drawbar - by stevec - 12-02-2012, 07:50 AM
RE: Poor Man's Power Drawbar - by DaveH - 12-02-2012, 10:21 AM
RE: Poor Man's Power Drawbar - by outlawspeeder - 07-05-2014, 12:26 AM
RE: Poor Man's Power Drawbar - by Mayhem - 07-05-2014, 03:44 AM
RE: Poor Man's Power Drawbar - by TomG - 07-05-2014, 09:56 AM
RE: Poor Man's Power Drawbar - by DaveH - 07-05-2014, 12:01 PM
RE: Poor Man's Power Drawbar - by outlawspeeder - 07-06-2014, 12:59 AM
|
