12-01-2012, 06:03 PM
I would run the break-in procedure on page 15 of this manual.
http://cdn0.grizzly.com/manuals/g0484_m.pdf
That mill is an RF-45 clone also.
This is the recommended oil for our mills.
http://www.use-enco.com/CGI/INSRIT?PARTP...NO=5830124
I would change the oil prior to running the mill too much. The stuff they call oil that is installed at the factory may be oil but it's mystery oil. My mill had what looked like used motor oil in it when I got it.
Ed
http://cdn0.grizzly.com/manuals/g0484_m.pdf
That mill is an RF-45 clone also.
This is the recommended oil for our mills.
http://www.use-enco.com/CGI/INSRIT?PARTP...NO=5830124
I would change the oil prior to running the mill too much. The stuff they call oil that is installed at the factory may be oil but it's mystery oil. My mill had what looked like used motor oil in it when I got it.
Ed