RF45 mill breakin recommendations
#2
I'd change the oil first, then look at it carefully to see if you can see any crud or sand particles in it. Put the oil in a white pan , the particles , if any will show up better.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
RF45 mill breakin recommendations - by DanH - 12-01-2012, 04:03 PM
RE: RF45 mill breakin recommendations - by sasquatch - 12-01-2012, 05:44 PM
RE: RF45 mill breakin recommendations - by EdK - 12-01-2012, 06:03 PM
RE: RF45 mill breakin recommendations - by DanH - 12-02-2012, 10:39 AM



Users browsing this thread: 2 Guest(s)