11-30-2012, 12:35 PM
So on to the next tool, the milling spindle.
This was made from part of a metal chair leg.
2 brass pipe fittings.
Piece of scrap plate
And a length of steel bar from the local blacksmith (free)
It fits on the vertical slide and is driven by a motor on the end of the lathe bed.
Yes the motor is OK under my rules, it is off the Bench drill.
Brian.
This was made from part of a metal chair leg.
2 brass pipe fittings.
Piece of scrap plate
And a length of steel bar from the local blacksmith (free)
It fits on the vertical slide and is driven by a motor on the end of the lathe bed.
Yes the motor is OK under my rules, it is off the Bench drill.
Brian.
