Looking for Recommendations on RT

[henryarnold]

(11-17-2012, 07:43 PM)dalee Wrote: Hi,

It looks like I my have a few extra dineros at my disposal. And I think I would like to add a horizontal/vertical rotary table to my Grizzly G0704 mill.

I think a 6" size should be appropriate for my mill. I have so far looked at Grizzly and CDCO. Both offer a 6" with a dividing set to go with. Grizzly comes all together, CDCO the dividing plate kit is extra. Price difference is about twenty bucks. I've perused eBay a bit but haven't seen anything in that size range.

I understand Chinese RT can suffer variable QC. So does anyone have other recommendations? Have an RT from Grizzly or CDCO?

As usual, all comments, insights, jokes and stories are welcome.

dalee

I bought a Grizzly setup which is so so. If I had it to do over, I would buy a Phase II Rotary table. They seem to offer the best quality for a low price.