|
Drill Press Adapter Plate
|
11-17-2012, 06:40 PM
An alterternative to the hex nuts might be some low-profile quick-lock handles. Here's a page from McMaster Carr with some ideas. It could make a great idea even easier to use.
http://www.mcmaster.com/#control-handles/=k7iqdy |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Drill Press Adapter Plate - by the penguin - 11-16-2012, 10:46 PM
RE: Drill Press Adapter Plate - by 4R8 - 11-17-2012, 03:16 PM
RE: Drill Press Adapter Plate - by sasquatch - 11-17-2012, 03:34 PM
RE: Drill Press Adapter Plate - by doubleboost - 11-17-2012, 03:50 PM
RE: Drill Press Adapter Plate - by PixMan - 11-17-2012, 06:40 PM
RE: Drill Press Adapter Plate - by stevec - 11-18-2012, 07:52 AM
RE: Drill Press Adapter Plate - by sasquatch - 11-18-2012, 09:11 AM
RE: Drill Press Adapter Plate - by TomG - 11-18-2012, 10:57 AM
RE: Drill Press Adapter Plate - by EdK - 11-18-2012, 11:09 AM
RE: Drill Press Adapter Plate - by ETC57 - 11-18-2012, 01:38 PM
RE: Drill Press Adapter Plate - by Wawoodman - 11-18-2012, 01:50 PM
|
