Head Studs
#7
(03-19-2012, 03:17 AM)B34VD Wrote: Does the engine have a miss? If you had an injector that was dumping enough raw fuel into a cyl to raise the oil level the piston would look like an orange. If the engine runs smoothly and the problem is fuel in the oil, check the fuel supply pump.

Engine has a miss at low rpm light load until you put your foot into it then it clears up and runs fine, smokes heavily at low speed also idle, when doing cutout test smoke clears when #5 cyl is cutout, generally power is down some especially below 1400 rpm when boost drops off some, above 1500 rpm with your foot into it it pulls well, still runs up to 45-50 lbs boost. n fuel restricrion is very low but U will check fuel supply pump also as it haqs never been changed. tom
Logan 10x26" lathe
SIEG 12x40" lathe
RongFU 45 clone mill
6" import band saw
Baldor Grinder
thousand of tools+tooling pieces 40 yrs of collecting
Reply
Thanks given by:


Messages In This Thread
Head Studs - by TOM REED - 03-18-2012, 08:48 AM
RE: HEAD STUDS - by PixMan - 03-18-2012, 11:39 AM
RE: HEAD STUDS - by B34VD - 03-18-2012, 02:40 PM
RE: HEAD STUDS - by ETC57 - 03-18-2012, 04:30 PM
RE: HEAD STUDS - by TOM REED - 03-18-2012, 09:08 PM
RE: HEAD STUDS - by B34VD - 03-19-2012, 03:17 AM
RE: HEAD STUDS - by TOM REED - 03-19-2012, 05:22 AM
RE: HEAD STUDS - by B34VD - 03-19-2012, 07:04 AM
RE: HEAD STUDS - by TOM REED - 03-19-2012, 01:18 PM
RE: HEAD STUDS - by B34VD - 03-19-2012, 03:26 PM
RE: HEAD STUDS - by krv3000 - 03-20-2012, 09:20 AM
RE: HEAD STUDS - by aametalmaster - 03-27-2012, 06:39 PM
RE: HEAD STUDS - by TOM REED - 03-28-2012, 01:00 AM
RE: HEAD STUDS - by TOM REED - 04-03-2012, 06:23 PM
RE: HEAD STUDS - by EdK - 04-03-2012, 06:40 PM
RE: HEAD STUDS - by TOM REED - 04-04-2012, 02:14 AM
RE: HEAD STUDS - by EdK - 04-04-2012, 06:42 AM
RE: HEAD STUDS - by Highpower - 04-04-2012, 06:57 AM



Users browsing this thread: 1 Guest(s)