Best Yet Knurling Tool

[stevec]

(11-11-2012, 08:28 PM)TomG Wrote: Shoulder bolts would probably be ok if all you did was fine pitch knurling, but coarser pitches would likely shear off the threaded end where it's undercut from the increased pressure.

One could use shoulder bolts with a long enough shoulder to enter a counterbore on the threaded side of the knurling tool.

(11-11-2012, 08:28 PM)TomG Wrote: Besides, shoulder bolts are not likely to be as hard as knurl pins
Tom

Probably true!