11-11-2012, 08:28 PM
The pins come out of mine with just a punch and a hammer. I still have several sets of holders with different knurls in them just because it's quicker to swap them out that way than to mess with the pins.
Once you get the pins out, just lap the holes a little larger until the pins come out easier. Shoulder bolts would probably be ok if all you did was fine pitch knurling, but coarser pitches would likely shear off the threaded end where it's undercut from the increased pressure. Besides, shoulder bolts are not likely to be as hard as knurl pins
Tom
Once you get the pins out, just lap the holes a little larger until the pins come out easier. Shoulder bolts would probably be ok if all you did was fine pitch knurling, but coarser pitches would likely shear off the threaded end where it's undercut from the increased pressure. Besides, shoulder bolts are not likely to be as hard as knurl pins
Tom