Head Studs
#5
(03-18-2012, 04:30 PM)ETC57 Wrote: Tom, probably already been there but have you called cat to see if they have an existing part for your app in stock?

Just a thought.Smile

Jerry.Popcorn

Nothing avail from cat but replacement studs, I may be lucky though I originally diagnosed my problem as injector failure,m the head gasket diagnosis was from cat, they said cold cyl because of a pushed head gasket and they also said I could run it for a while till it started going thru antifreeze, also quoted $25,000.00 plus for a complete overhaul. It just had inframe 2 yrs ago. Anyway today it started making oil (diesel in the oil) which again p[opints to injector so tomorrow if possible will get the injector pulled on #5 hole and get a leak down test done which will tell me if the head gasket is the problem or not. I really still think it is an injector/injector cup problem at least I sure hope so 1 new injector abt $600.00 installed a newe set of 6 for about $3800.00. Will keep my fingers and toes crossed. tom
Logan 10x26" lathe
SIEG 12x40" lathe
RongFU 45 clone mill
6" import band saw
Baldor Grinder
thousand of tools+tooling pieces 40 yrs of collecting
Reply
Thanks given by:


Messages In This Thread
Head Studs - by TOM REED - 03-18-2012, 08:48 AM
RE: HEAD STUDS - by PixMan - 03-18-2012, 11:39 AM
RE: HEAD STUDS - by B34VD - 03-18-2012, 02:40 PM
RE: HEAD STUDS - by ETC57 - 03-18-2012, 04:30 PM
RE: HEAD STUDS - by TOM REED - 03-18-2012, 09:08 PM
RE: HEAD STUDS - by B34VD - 03-19-2012, 03:17 AM
RE: HEAD STUDS - by TOM REED - 03-19-2012, 05:22 AM
RE: HEAD STUDS - by B34VD - 03-19-2012, 07:04 AM
RE: HEAD STUDS - by TOM REED - 03-19-2012, 01:18 PM
RE: HEAD STUDS - by B34VD - 03-19-2012, 03:26 PM
RE: HEAD STUDS - by krv3000 - 03-20-2012, 09:20 AM
RE: HEAD STUDS - by aametalmaster - 03-27-2012, 06:39 PM
RE: HEAD STUDS - by TOM REED - 03-28-2012, 01:00 AM
RE: HEAD STUDS - by TOM REED - 04-03-2012, 06:23 PM
RE: HEAD STUDS - by EdK - 04-03-2012, 06:40 PM
RE: HEAD STUDS - by TOM REED - 04-04-2012, 02:14 AM
RE: HEAD STUDS - by EdK - 04-04-2012, 06:42 AM
RE: HEAD STUDS - by Highpower - 04-04-2012, 06:57 AM



Users browsing this thread: 10 Guest(s)