|
9X20 Spindle Hand Wheel
|
11-09-2012, 05:39 PM
(11-09-2012, 05:00 PM)Bill Gruby Wrote: You can say that again Ed. The threas should read like this. 1.125-40X.187. now thats one short run of threads 
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
9X20 Spindle Hand Wheel - by Bill Gruby - 11-09-2012, 10:14 AM
RE: 9X20 Spindle Hand Wheel - by Que - 11-09-2012, 10:34 AM
RE: 9X20 Spindle Hand Wheel - by Bill Gruby - 11-09-2012, 01:36 PM
RE: 9X20 Spindle Hand Wheel - by dallen - 11-09-2012, 01:37 PM
RE: 9X20 Spindle Hand Wheel - by Bill Gruby - 11-09-2012, 02:36 PM
RE: 9X20 Spindle Hand Wheel - by dallen - 11-09-2012, 03:54 PM
RE: 9X20 Spindle Hand Wheel - by EdK - 11-09-2012, 04:57 PM
RE: 9X20 Spindle Hand Wheel - by stevec - 11-09-2012, 04:57 PM
RE: 9X20 Spindle Hand Wheel - by EdK - 11-09-2012, 04:59 PM
RE: 9X20 Spindle Hand Wheel - by Bill Gruby - 11-09-2012, 05:00 PM
RE: 9X20 Spindle Hand Wheel - by dallen - 11-09-2012, 05:39 PM
RE: 9X20 Spindle Hand Wheel - by Bill Gruby - 11-09-2012, 06:42 PM
RE: 9X20 Spindle Hand Wheel - by stevec - 11-09-2012, 07:09 PM
RE: 9X20 Spindle Hand Wheel - by DaveH - 11-10-2012, 05:20 PM
RE: 9X20 Spindle Hand Wheel - by Mayhem - 11-10-2012, 09:49 PM
RE: 9X20 Spindle Hand Wheel - by Bill Gruby - 11-10-2012, 09:58 PM
RE: 9X20 Spindle Hand Wheel - by stevec - 11-11-2012, 08:44 AM
RE: 9X20 Spindle Hand Wheel - by dalee - 11-10-2012, 10:16 PM
RE: 9X20 Spindle Hand Wheel - by dallen - 11-10-2012, 11:14 PM
RE: 9X20 Spindle Hand Wheel - by Bill Gruby - 11-11-2012, 11:35 AM
RE: 9X20 Spindle Hand Wheel - by stevec - 11-11-2012, 11:56 AM
RE: 9X20 Spindle Hand Wheel - by pamrick - 11-27-2012, 07:31 PM
RE: 9X20 Spindle Hand Wheel - by Mayhem - 11-28-2012, 07:09 AM
RE: 9X20 Spindle Hand Wheel - by Bill Gruby - 11-28-2012, 11:26 AM
|
