11-05-2012, 11:56 AM
In my case it isn't held at all Ed. I just have a flat bottom on the ram. I line it up vertically the best I can, and let the pressure off frequently to check to see that it isn't bound up or being pushed at an angle.
It's actually a 3 ton press and that particular broach is not the biggest one in my set - and it barely fit under the ram after removing the press plate from the base. My largest broach won't fit at all and I HAVE to use my 20 ton shop press with that one.
It's actually a 3 ton press and that particular broach is not the biggest one in my set - and it barely fit under the ram after removing the press plate from the base. My largest broach won't fit at all and I HAVE to use my 20 ton shop press with that one.
Willie