Indexable End Mills
#5
(11-05-2012, 08:57 AM)Mayhem Wrote: Sorry Jack, I misread your post. I guess I need to stop reading this forum on my phone.

No problem, maybe I wasn't clear in my question.

the indexable end mills can be dirt cheap, all the way to costly, are they viable?? or in the long run would it be better (and cheaper) to use regular carbide end mills??

I have a couple of cheap sets that use the CCMT inserts and a more expensive set that uses the AKPT inserts, there may be still better options. Being that I'm a hobbyist, I'm not sure which one to use where or if at all.
jack
Reply
Thanks given by:


Messages In This Thread
Indexable End Mills - by the penguin - 11-05-2012, 07:57 AM
RE: Indexable End Mills - by Mayhem - 11-05-2012, 08:25 AM
RE: Indexable End Mills - by the penguin - 11-05-2012, 08:48 AM
RE: Indexable End Mills - by Mayhem - 11-05-2012, 08:57 AM
RE: Indexable End Mills - by the penguin - 11-05-2012, 09:30 AM
RE: Indexable End Mills - by Mayhem - 11-05-2012, 09:52 AM
RE: Indexable End Mills - by EdK - 11-05-2012, 10:25 AM
RE: Indexable End Mills - by PixMan - 11-05-2012, 07:49 PM
RE: Indexable End Mills - by the penguin - 11-05-2012, 11:07 PM



Users browsing this thread: 3 Guest(s)