I'm getting a quote on the nut. It will most likely cost less to buy it than it would to buy the material and make it myself. I have actually been surprised by the cost of the parts I have had quoted so far.
Before I managed to get the high resolution drawing of the Kondia FV-1 head, I often looked at the Industrial Control and Automation web site, which has an interactive exploded drawing of the head of a J series BP. I have found this quite helpful in identifying parts on my mill. This was especially helpful when the Spanish -> English translation leaves you with a part description "sleeve of conicals". Anyone care to guess what that is?
If you click on a part it will then show you the price of that part. I was very worried when I saw that the worm gear cradle lists at US$201.82. Fortunately, the Kondia worm gear cradle lists at 29.30 Euro (US$30.68).
Before I managed to get the high resolution drawing of the Kondia FV-1 head, I often looked at the Industrial Control and Automation web site, which has an interactive exploded drawing of the head of a J series BP. I have found this quite helpful in identifying parts on my mill. This was especially helpful when the Spanish -> English translation leaves you with a part description "sleeve of conicals". Anyone care to guess what that is?
If you click on a part it will then show you the price of that part. I was very worried when I saw that the worm gear cradle lists at US$201.82. Fortunately, the Kondia worm gear cradle lists at 29.30 Euro (US$30.68).
Hunting American dentists since 2015.