11-02-2012, 02:40 PM
My x-axis movement is good in the middle of the travel but tightens up at each end in the last 3 to 4 inches. I bought it new in Feb and most of the work I have done has been in the middle of the table until recently so I hadn't noticed the difference. Does this mean the gibs need to be adjusted? Could it just be a breakin issue?
The y-axis is smooth for the full travel but that's only 8 in compared to 22 in.
Dan
The y-axis is smooth for the full travel but that's only 8 in compared to 22 in.
Dan
Collecting tools for 30 years.