Tee Slot Cutters

Thread Modes

Tee Slot Cutters

Turbinedoctor
Unregistered

#11

03-17-2012, 01:16 AM

So if I go about .005 wider and .010/.015 deeper I should be OK?

I am planning on making some Bimini top slide rails out of aluminum for my boat.

« Next Oldest | Next Newest »

Messages In This Thread

Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:23 PM

RE: Tee Slot Cutters - by stevec - 03-16-2012, 07:34 PM

RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:48 PM

RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:55 PM

RE: Tee Slot Cutters - by DaveH - 03-16-2012, 07:58 PM

RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 08:16 PM

RE: Tee Slot Cutters - by DaveH - 03-16-2012, 08:25 PM

RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 08:51 PM

RE: Tee Slot Cutters - by PixMan - 03-16-2012, 09:15 PM

RE: Tee Slot Cutters - by Turbinedoctor - 03-17-2012, 01:16 AM

RE: Tee Slot Cutters - by PixMan - 03-17-2012, 08:16 AM

RE: Tee Slot Cutters - by EdK - 03-17-2012, 09:11 AM

RE: Tee Slot Cutters - by Turbinedoctor - 03-17-2012, 05:40 PM

Users browsing this thread: 2 Guest(s)