03-16-2012, 08:16 PM
When cutting a tee slot, how much clearance is needed above the diameter of the shank that is just above the cutter. Say it is for a 1/4" bolt and the shank dia is .250 how much extra should I allow?
|
Tee Slot Cutters
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:23 PM
RE: Tee Slot Cutters - by stevec - 03-16-2012, 07:34 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:48 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:55 PM
RE: Tee Slot Cutters - by DaveH - 03-16-2012, 07:58 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 08:16 PM
RE: Tee Slot Cutters - by DaveH - 03-16-2012, 08:25 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 08:51 PM
RE: Tee Slot Cutters - by PixMan - 03-16-2012, 09:15 PM
RE: Tee Slot Cutters - by Tony Wells - 03-16-2012, 09:58 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-17-2012, 01:16 AM
RE: Tee Slot Cutters - by PixMan - 03-17-2012, 08:16 AM
RE: Tee Slot Cutters - by EdK - 03-17-2012, 09:11 AM
RE: Tee Slot Cutters - by Turbinedoctor - 03-17-2012, 05:40 PM
|
Users browsing this thread: 3 Guest(s)