MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tee Slot Cutters

Thread Modes
Tee Slot Cutters
Turbinedoctor
Unregistered
 
#3
03-16-2012, 07:48 PM
Is there a standard depth of cut for the diameter. If I am getting a 3/4" wide cutter is there a standard depth or thickness I can expect it to be?

The one I am looking at don't mention this.
Reply
Thanks given by:


Messages In This Thread
Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:23 PM
RE: Tee Slot Cutters - by stevec - 03-16-2012, 07:34 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:48 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 07:55 PM
RE: Tee Slot Cutters - by DaveH - 03-16-2012, 07:58 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 08:16 PM
RE: Tee Slot Cutters - by DaveH - 03-16-2012, 08:25 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-16-2012, 08:51 PM
RE: Tee Slot Cutters - by PixMan - 03-16-2012, 09:15 PM
RE: Tee Slot Cutters - by Tony Wells - 03-16-2012, 09:58 PM
RE: Tee Slot Cutters - by Turbinedoctor - 03-17-2012, 01:16 AM
RE: Tee Slot Cutters - by PixMan - 03-17-2012, 08:16 AM
RE: Tee Slot Cutters - by EdK - 03-17-2012, 09:11 AM
RE: Tee Slot Cutters - by Turbinedoctor - 03-17-2012, 05:40 PM



Users browsing this thread: 2 Guest(s)