Cheap Chinese Motor

[dallen]

(10-17-2012, 07:31 AM)Mayhem Wrote: Nice work. I'd like to see some more pics/info of your muller.

Mayhem I'll see about taking some shots of it and post them up to you. I based the muller off of one built by Steve Chastian, but I made a lot of changes to it in the drive as I didn't think I needed one as heavy as he built his. He got into actually casting a gear box case for his which I didn't see that I needed. Actually a right angle gear box of about a 40 to 1 ratio is pretty much the right speed. the drive shaft is pretty heavy I used a piece of 1 7/16" round bar to make mine out of.

here's the photos of the spacer ready to install under the motor as soon as a buddy of mine shows up to lend a hand to slide the spacer in when I pick the motor up.





and its installed