03-15-2012, 10:28 PM
I found some time today and made a small fly cutter for gear making, arbors are made a couple of days ago. Now I have to cut a 1/4" HSS cutter to fit a gear profile. I thought I would start off with a small gear to try, since I do not have any big material to use for now. Now I just have to pic a gear to try out and start cutting. I do have to go to the store to buy a set screw, I thought I had some but they were all to big. I made the fly cutter to fit my Sherline Mill and the arbor to fit the rotary table and chuck. The stem does not show up on the pic, but I made it fit the holder in the mill.
Paul
Paul
pjf134, proud to be a member of MetalworkingFun Forum since Feb 2012.