MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Parting off tool holder

Thread Modes
Parting off tool holder
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
#9
03-15-2012, 04:58 PM
(03-15-2012, 05:46 AM)Mayhem Wrote: How does this affect the rigidity of the tool?
Hi
The tool is more rigid than a small tool in a holder (you can not get it any nearer to the tool post )
The best bit is you can pick up large tooling & tips much cheaper than small stuff
John

http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
Parting off tool holder - by doubleboost - 03-10-2012, 05:18 PM
RE: Parting off tool holder - by DaveH - 03-10-2012, 07:27 PM
RE: Parting off tool holder - by doubleboost - 03-13-2012, 06:31 PM
RE: Parting off tool holder - by DaveH - 03-13-2012, 06:51 PM
RE: Parting off tool holder - by doubleboost - 03-13-2012, 07:00 PM
RE: Parting off tool holder - by TOM REED - 03-14-2012, 12:58 PM
RE: Parting off tool holder - by B34VD - 03-15-2012, 04:41 PM
RE: Parting off tool holder - by Mayhem - 03-15-2012, 05:46 AM
RE: Parting off tool holder - by doubleboost - 03-15-2012, 04:58 PM
RE: Parting off tool holder - by doubleboost - 03-15-2012, 05:21 PM
RE: Parting off tool holder - by DaveH - 03-20-2012, 09:12 AM
RE: Parting off tool holder - by doubleboost - 03-20-2012, 12:10 PM
RE: Parting off tool holder - by PixMan - 09-14-2012, 08:28 PM
RE: Parting off tool holder - by EdK - 09-14-2012, 08:31 PM
RE: Parting off tool holder - by PixMan - 09-14-2012, 09:28 PM



Users browsing this thread: 4 Guest(s)