10-10-2012, 10:15 PM
Dave, which roller do you move on yours to adjust the radius? The top and side one both look like they have movement.
PixMan, The two bottom rollers are about 5 or 6 inches apart hence the flat at the end, the further apart they are the less pressure it takes to bend the plate to the yield point. I have a hand crank directly connected to one of the bottom rollers, the second is chain driven off it. Takes very little torque to move the plate.
PixMan, The two bottom rollers are about 5 or 6 inches apart hence the flat at the end, the further apart they are the less pressure it takes to bend the plate to the yield point. I have a hand crank directly connected to one of the bottom rollers, the second is chain driven off it. Takes very little torque to move the plate.
Free advice is worth exactly what you payed for it.
Greg
Greg