10-10-2012, 10:07 PM
Need just over 4 feet on the gantry, enough to get the end of a sheet in, as for length, somewhere between 2 and 4. 2 x 4 foot would probably cut 99% of the parts I need, but 4 x 4 might be more practical, as long as the end of the sheet can hang out.
High speed is nice but usually equates to higher cost as in bigger steppers and the supplies and driver to run them. If this thing will cut out my parts accurately the time saving will be there, moving between parts doesn't really matter.
High speed is nice but usually equates to higher cost as in bigger steppers and the supplies and driver to run them. If this thing will cut out my parts accurately the time saving will be there, moving between parts doesn't really matter.
Free advice is worth exactly what you payed for it.
Greg
Greg