MetalworkingFun Forum › Machining › Projects v
Roller Benders

Thread Modes
Roller Benders
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#7
10-10-2012, 06:56 PM
Very nice Dave, slightly more refined than mine. Mine leaves about 2 inches flat at the ends but will roll 1/2 inch plate. Here its bending 5/16 plate 12 inches wide.

[Image: IMGP1255.jpg]
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Roller Benders - by DaveH - 10-10-2012, 01:14 PM
RE: Roller Benders - by DaveH - 10-10-2012, 01:28 PM
RE: Roller Benders - by TomG - 10-10-2012, 02:15 PM
RE: Roller Benders - by doubleboost - 10-10-2012, 03:29 PM
RE: Roller Benders - by DaveH - 10-10-2012, 03:35 PM
RE: Roller Benders - by EdK - 10-10-2012, 04:08 PM
RE: Roller Benders - by f350ca - 10-10-2012, 06:56 PM
RE: Roller Benders - by Highpower - 10-10-2012, 08:35 PM
RE: Roller Benders - by PixMan - 10-10-2012, 09:25 PM
RE: Roller Benders - by ETC57 - 10-10-2012, 09:40 PM
RE: Roller Benders - by f350ca - 10-10-2012, 10:15 PM
RE: Roller Benders - by stevec - 10-11-2012, 04:16 AM
RE: Roller Benders - by EdK - 10-11-2012, 06:04 AM
RE: Roller Benders - by DaveH - 10-11-2012, 07:38 AM
RE: Roller Benders - by dallen - 10-11-2012, 09:08 AM
RE: Roller Benders - by DaveH - 10-11-2012, 09:42 AM
RE: Roller Benders - by DanH - 10-11-2012, 12:24 PM
RE: Roller Benders - by DaveH - 10-11-2012, 01:28 PM
RE: Roller Benders - by monkers - 12-01-2012, 12:27 AM



Users browsing this thread: 3 Guest(s)