MetalworkingFun Forum › Machining › General Metalworking Discussion v
In, or out?

Thread Modes
In, or out?
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#19
10-08-2012, 05:47 AM
I read the thread title and was disappointed when I saw it wasn't instructions for doing the Hokey Pokey!

Almost all of my tools are kept in tool chests, filing cabinets, boxes etc. I have a selection of hand tools on my electronics bench that are on the wall (magnetic holder or pegs). Drills are kept in their indexes or in wooden blocks by the drill. Lathe tools in a dedicated cabinet.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
In, or out? - by Wawoodman - 10-06-2012, 11:00 AM
RE: In, or out? - by wrustle - 10-06-2012, 11:25 AM
RE: In, or out? - by EdK - 10-06-2012, 11:43 AM
RE: In, or out? - by wrustle - 10-06-2012, 12:07 PM
RE: In, or out? - by EdK - 10-06-2012, 12:59 PM
RE: In, or out? - by dallen - 10-06-2012, 12:33 PM
RE: In, or out? - by EdK - 10-06-2012, 12:59 PM
RE: In, or out? - by stevec - 10-06-2012, 04:02 PM
RE: In, or out? - by Wawoodman - 10-06-2012, 05:45 PM
RE: In, or out? - by PixMan - 10-06-2012, 06:33 PM
RE: In, or out? - by f350ca - 10-06-2012, 06:36 PM
RE: In, or out? - by TomG - 10-06-2012, 08:43 PM
RE: In, or out? - by rleete - 10-06-2012, 08:45 PM
RE: In, or out? - by sasquatch - 10-06-2012, 09:18 PM
RE: In, or out? - by f350ca - 10-06-2012, 10:38 PM
RE: In, or out? - by TOM REED - 10-07-2012, 02:56 AM
RE: In, or out? - by Arbalest - 10-07-2012, 04:19 AM
RE: In, or out? - by krv3000 - 10-07-2012, 04:02 PM
RE: In, or out? - by Mayhem - 10-08-2012, 05:47 AM



Users browsing this thread: 1 Guest(s)