MetalworkingFun Forum › Machining › Projects v
Adding power to the z-axis

Thread Modes
Adding power to the z-axis
DanH Offline
Sophmore
***
Posts: 157
Threads: 18
Joined: Apr 2012
Location: Damascus, Or
#11
10-07-2012, 01:57 PM
Dallen,

Even with the 2 springs it took more than a 2 fingered force to move the head. I noticed that with the RF45 mills that had the crank on the right side, the crank looked much shorter than mine. Maybe the worm gear ratio is different?

Dan
Collecting tools for 30 years.
Reply
Thanks given by:


Messages In This Thread
Adding power to the z-axis - by DanH - 10-06-2012, 12:30 PM
RE: Adding power to the z-axis - by DanH - 10-06-2012, 12:56 PM
RE: Adding power to the z-axis - by EdK - 10-06-2012, 01:06 PM
RE: Adding power to the z-axis - by DanH - 10-06-2012, 01:31 PM
RE: Adding power to the z-axis - by Highpower - 10-06-2012, 08:45 PM
RE: Adding power to the z-axis - by DanH - 10-06-2012, 09:05 PM
RE: Adding power to the z-axis - by Wawoodman - 10-07-2012, 09:26 AM
RE: Adding power to the z-axis - by DanH - 10-07-2012, 01:52 PM
RE: Adding power to the z-axis - by TomG - 10-07-2012, 09:44 AM
RE: Adding power to the z-axis - by dallen - 10-07-2012, 10:05 AM
RE: Adding power to the z-axis - by DanH - 10-07-2012, 01:57 PM
RE: Adding power to the z-axis - by petertha - 10-20-2012, 08:48 PM
RE: Adding power to the z-axis - by DanH - 10-20-2012, 09:43 PM



Users browsing this thread: 2 Guest(s)