MetalworkingFun Forum › Machining › General Metalworking Discussion v
In, or out?

Thread Modes
In, or out?
Arbalest Offline
Sophmore
***
Posts: 175
Threads: 4
Joined: Sep 2012
Location: Dorset, UK
#17
10-07-2012, 04:19 AM
Most of my stuff are on shelves in cupboards as the workshop can be quite damp. Lathe tools, punches and T handle drivers are notable exceptions that live out!
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
In, or out? - by Wawoodman - 10-06-2012, 11:00 AM
RE: In, or out? - by wrustle - 10-06-2012, 11:25 AM
RE: In, or out? - by EdK - 10-06-2012, 11:43 AM
RE: In, or out? - by wrustle - 10-06-2012, 12:07 PM
RE: In, or out? - by EdK - 10-06-2012, 12:59 PM
RE: In, or out? - by dallen - 10-06-2012, 12:33 PM
RE: In, or out? - by EdK - 10-06-2012, 12:59 PM
RE: In, or out? - by stevec - 10-06-2012, 04:02 PM
RE: In, or out? - by Wawoodman - 10-06-2012, 05:45 PM
RE: In, or out? - by PixMan - 10-06-2012, 06:33 PM
RE: In, or out? - by f350ca - 10-06-2012, 06:36 PM
RE: In, or out? - by TomG - 10-06-2012, 08:43 PM
RE: In, or out? - by rleete - 10-06-2012, 08:45 PM
RE: In, or out? - by sasquatch - 10-06-2012, 09:18 PM
RE: In, or out? - by f350ca - 10-06-2012, 10:38 PM
RE: In, or out? - by TOM REED - 10-07-2012, 02:56 AM
RE: In, or out? - by Arbalest - 10-07-2012, 04:19 AM
RE: In, or out? - by krv3000 - 10-07-2012, 04:02 PM
RE: In, or out? - by Mayhem - 10-08-2012, 05:47 AM



Users browsing this thread: 1 Guest(s)