MetalworkingFun Forum › Machining › General Metalworking Discussion v
In, or out?

Thread Modes
In, or out?
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#12
10-06-2012, 08:43 PM
Everything in my shop has a place in a drawer of cabinet with the exception of big things like vises, dividing heads and rotary tables. It doesn't always find its way back, but it does have a place. There is no way that I would have room to keep everything out.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
In, or out? - by Wawoodman - 10-06-2012, 11:00 AM
RE: In, or out? - by wrustle - 10-06-2012, 11:25 AM
RE: In, or out? - by EdK - 10-06-2012, 11:43 AM
RE: In, or out? - by wrustle - 10-06-2012, 12:07 PM
RE: In, or out? - by EdK - 10-06-2012, 12:59 PM
RE: In, or out? - by dallen - 10-06-2012, 12:33 PM
RE: In, or out? - by EdK - 10-06-2012, 12:59 PM
RE: In, or out? - by stevec - 10-06-2012, 04:02 PM
RE: In, or out? - by Wawoodman - 10-06-2012, 05:45 PM
RE: In, or out? - by PixMan - 10-06-2012, 06:33 PM
RE: In, or out? - by f350ca - 10-06-2012, 06:36 PM
RE: In, or out? - by TomG - 10-06-2012, 08:43 PM
RE: In, or out? - by rleete - 10-06-2012, 08:45 PM
RE: In, or out? - by sasquatch - 10-06-2012, 09:18 PM
RE: In, or out? - by f350ca - 10-06-2012, 10:38 PM
RE: In, or out? - by TOM REED - 10-07-2012, 02:56 AM
RE: In, or out? - by Arbalest - 10-07-2012, 04:19 AM
RE: In, or out? - by krv3000 - 10-07-2012, 04:02 PM
RE: In, or out? - by Mayhem - 10-08-2012, 05:47 AM



Users browsing this thread: 2 Guest(s)