Fractional/1-60/A-G drill index: Out on dad's bench
S & D bits: In wood bloack set on shelf by the milling machine
Metric bits: In 3rd drawer down, dad's Kennedy 295B roll-around, left hand side
Collets: In steel rack on shelf to the right of the lathe
Lathe toolholders: In a slide-out rack made by dad, under the 24x36 suface plate table, behind the lathe operator
T-handle hex wrench: No set, couple in top drawer, RH side of my Kennedy 297B roll-around
Regular hex wrench: Second drawer, RH side of my Kennedy 297B, set of combination inch, various open end metrics
Nutdrivers: None. 3/8" and 1/4" drive ratchet & socket set in above location with wrenches.
Other stuff: Taps, reamers, boring bars, wrenches, screwdrivers...Stuff in every drawer, shelf, nook and cranny
If you want to see the photos they tell a story faster, but that ends up looking like the tool gloat it is. Messy gloat (as compared to most others), but a lot of stuff in various shelves and drawers.
S & D bits: In wood bloack set on shelf by the milling machine
Metric bits: In 3rd drawer down, dad's Kennedy 295B roll-around, left hand side
Collets: In steel rack on shelf to the right of the lathe
Lathe toolholders: In a slide-out rack made by dad, under the 24x36 suface plate table, behind the lathe operator
T-handle hex wrench: No set, couple in top drawer, RH side of my Kennedy 297B roll-around
Regular hex wrench: Second drawer, RH side of my Kennedy 297B, set of combination inch, various open end metrics
Nutdrivers: None. 3/8" and 1/4" drive ratchet & socket set in above location with wrenches.
Other stuff: Taps, reamers, boring bars, wrenches, screwdrivers...Stuff in every drawer, shelf, nook and cranny
If you want to see the photos they tell a story faster, but that ends up looking like the tool gloat it is. Messy gloat (as compared to most others), but a lot of stuff in various shelves and drawers.