MetalworkingFun Forum › Machining › General Metalworking Discussion v
In, or out?

Thread Modes
In, or out?
Wawoodman
Unregistered
 
#9
10-06-2012, 05:45 PM
(10-06-2012, 04:02 PM)stevec Wrote: The advantage of having to hunt through the piles is that you come across things you were looking for recently and are relieved to know they're not gone.Blush

Ah, yes. The old "can't find it? Buy another one to make it reappear" principle of tooling.
Reply
Thanks given by:


Messages In This Thread
In, or out? - by Wawoodman - 10-06-2012, 11:00 AM
RE: In, or out? - by wrustle - 10-06-2012, 11:25 AM
RE: In, or out? - by EdK - 10-06-2012, 11:43 AM
RE: In, or out? - by wrustle - 10-06-2012, 12:07 PM
RE: In, or out? - by EdK - 10-06-2012, 12:59 PM
RE: In, or out? - by dallen - 10-06-2012, 12:33 PM
RE: In, or out? - by EdK - 10-06-2012, 12:59 PM
RE: In, or out? - by stevec - 10-06-2012, 04:02 PM
RE: In, or out? - by Wawoodman - 10-06-2012, 05:45 PM
RE: In, or out? - by PixMan - 10-06-2012, 06:33 PM
RE: In, or out? - by f350ca - 10-06-2012, 06:36 PM
RE: In, or out? - by TomG - 10-06-2012, 08:43 PM
RE: In, or out? - by rleete - 10-06-2012, 08:45 PM
RE: In, or out? - by sasquatch - 10-06-2012, 09:18 PM
RE: In, or out? - by f350ca - 10-06-2012, 10:38 PM
RE: In, or out? - by TOM REED - 10-07-2012, 02:56 AM
RE: In, or out? - by Arbalest - 10-07-2012, 04:19 AM
RE: In, or out? - by krv3000 - 10-07-2012, 04:02 PM
RE: In, or out? - by Mayhem - 10-08-2012, 05:47 AM



Users browsing this thread: 1 Guest(s)