10-06-2012, 11:00 AM
Curious about how you folk have your tooling set up. What's in a drawer, and what's out on a shelf or pegboard?
For example:
Fractional/1-60/A-G drill index: OUT
S & D bits: OUT
Metric bits: IN
Collets: OUT
Lathe toolholders: IN
T-handle hex wrench: ?
Regular hex wrench: ?
Nutdrivers: ?
Other stuff: Taps, reamers, boring bars, wrenches, screwdrivers...
Obviously, this would change on specific jobs. But just, in general...?
For example:
Fractional/1-60/A-G drill index: OUT
S & D bits: OUT
Metric bits: IN
Collets: OUT
Lathe toolholders: IN
T-handle hex wrench: ?
Regular hex wrench: ?
Nutdrivers: ?
Other stuff: Taps, reamers, boring bars, wrenches, screwdrivers...
Obviously, this would change on specific jobs. But just, in general...?