Latest Delivery

[EdK]

(10-04-2012, 04:42 PM)DaveH Wrote: Ed,
Goodness me, I think he has taken a fancy to you
Nice looking 'stuff' there

DaveH

Thanks Dave. All of those drill bits and all but one of the taps were bought from Enco's clearance section for dirt cheap. The only thing I intended on ordering was the 5/16-24 taper point tap to finish off my cat head project. The boring bar was a "I could certainly use one of those" buys and the ER40 collets were bought to round out my ER40 collets so I'm ready once I get the collet chuck project finish. I now have ER40 collets in the following sizes.

3/16"
1/4"
5/16"
3/8"
7/16"
1/2"
9/16"
5/8"
3/4"

Those should cover most of my needs but I'll add others as I need them.

Ed