10-04-2012, 04:19 PM
With the "dead length" stop the part can't move as the collet draws in, the collets slide down the part and can mark it.
Free advice is worth exactly what you payed for it.
Greg
Greg
|
5C Collet Stop For The Lathe
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
5C Collet Stop For The Lathe - by EdK - 10-01-2012, 06:35 PM
RE: 5C Collet Stop For The Lathe - by PixMan - 10-01-2012, 07:05 PM
RE: 5C Collet Stop For The Lathe - by Bill Gruby - 10-04-2012, 11:17 AM
RE: 5C Collet Stop For The Lathe - by f350ca - 10-04-2012, 04:19 PM
RE: 5C Collet Stop For The Lathe - by EdK - 10-04-2012, 04:24 PM
RE: 5C Collet Stop For The Lathe - by Bill Gruby - 10-04-2012, 04:49 PM
|
Users browsing this thread: 1 Guest(s)