MetalworkingFun Forum › Machinery › Milling Machines v
Kurt Klone Kwality

Thread Modes
Kurt Klone Kwality
sasquatch Offline
Senior
*****
Posts: 825
Threads: 25
Joined: Jul 2012
Location: N. Bay Ontario
#8
10-03-2012, 07:35 PM
My 4inch vise appears to be ok, so far, i often wondered about it breaking from overtightning it, which i try not to do.

One thing that is just horrible on these vises is the "CLUB" of a handle they come with!!!
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Kurt Klone Kwality - by stevec - 10-03-2012, 07:54 AM
RE: Kurt Klone Kwality - by TomG - 10-03-2012, 08:38 AM
RE: Kurt Klone Kwality - by EdK - 10-03-2012, 09:45 AM
RE: Kurt Klone Kwality - by stevec - 10-03-2012, 09:55 AM
RE: Kurt Klone Kwality - by EdK - 10-03-2012, 10:48 AM
RE: Kurt Klone Kwality - by rleete - 10-03-2012, 06:04 PM
RE: Kurt Klone Kwality - by EdK - 10-03-2012, 06:17 PM
RE: Kurt Klone Kwality - by sasquatch - 10-03-2012, 07:35 PM
RE: Kurt Klone Kwality - by TOM REED - 10-04-2012, 01:37 AM
RE: Kurt Klone Kwality - by SnailPowered - 10-04-2012, 02:58 AM
RE: Kurt Klone Kwality - by rleete - 10-04-2012, 06:27 AM
RE: Kurt Klone Kwality - by PixMan - 10-04-2012, 06:44 AM
RE: Kurt Klone Kwality - by TOM REED - 10-04-2012, 10:01 AM
RE: Kurt Klone Kwality - by rleete - 10-04-2012, 08:17 PM
RE: Kurt Klone Kwality - by stevec - 10-07-2012, 06:55 AM
RE: Kurt Klone Kwality - by Highpower - 10-07-2012, 09:45 AM
RE: Kurt Klone Kwality - by stevec - 10-07-2012, 09:56 AM
RE: Kurt Klone Kwality - by TomG - 10-07-2012, 09:57 AM
RE: Kurt Klone Kwality - by Highpower - 10-07-2012, 10:06 AM



Users browsing this thread: 1 Guest(s)