10-01-2012, 08:10 PM
Yes Claude that setup looks really suitable, if you could add angular dimensioning to your cad drawing it would save me a whole heap of math work to verify the work you have already done, It really is an angular change we are trying to verify, incidentally do you have slip guages for this setup or are you intending to grind the block to the correct height each time?
If you are going with the latter may I suggest a screw jack and micrometer might be a whole heap easier to do the same job.
Best Regards
Rick
If you are going with the latter may I suggest a screw jack and micrometer might be a whole heap easier to do the same job.
Best Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.