MetalworkingFun Forum › Machining › General Metalworking Discussion v
Wondering?

Thread Modes
Wondering?
randyjaco Offline
Freshman
**
Posts: 12
Threads: 1
Joined: Jul 2012
Location: Friendswood TX
#7
09-28-2012, 06:31 PM
(09-28-2012, 06:25 PM)sasquatch Wrote: Thanks for the replies,, looking through the catalog, i'm thinking i will buy a few in "Stub Drill" lengths, mostly between 1/8th and just up to 1/2 inch.

I don't see that i will need a whole set, but a few sizes i could probably use at times.

Don't bother with the ones from Harbor Freight. They aren't much good for anything harder than aluminum Sadno

Randy
randyjaco, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Wondering? - by sasquatch - 09-27-2012, 07:51 PM
RE: Wondering? - by f350ca - 09-27-2012, 08:10 PM
RE: Wondering? - by sasquatch - 09-27-2012, 08:20 PM
RE: Wondering? - by Tony Wells - 09-27-2012, 10:25 PM
RE: Wondering? - by Highpower - 09-28-2012, 12:05 AM
RE: Wondering? - by sasquatch - 09-28-2012, 06:25 PM
RE: Wondering? - by randyjaco - 09-28-2012, 06:31 PM
RE: Wondering? - by sasquatch - 09-28-2012, 08:03 PM
RE: Wondering? - by dalee - 09-29-2012, 08:36 PM
RE: Wondering? - by mikecwik - 10-03-2012, 06:32 PM
RE: Wondering? - by stevec - 10-03-2012, 06:53 PM
RE: Wondering? - by sasquatch - 10-04-2012, 07:23 AM
RE: Wondering? - by Sunset Machine - 10-04-2012, 10:32 AM



Users browsing this thread: 2 Guest(s)