MetalworkingFun Forum › Machining › Projects v
new project

Thread Modes
new project
DanH Offline
Sophmore
***
Posts: 157
Threads: 18
Joined: Apr 2012
Location: Damascus, Or
#27
09-28-2012, 04:09 PM
(09-28-2012, 03:06 PM)dallen Wrote: had to make an attachment for the press today so I could press off a part that I shouldn't of pressed on there just yet

[Image: Horozonal-press003.jpg]

[Image: Horozonal-press002.jpg]

[Image: Horozonal-press001.jpg]

Slaphead

Now I know what that was in the pics on the first post. I didn't pickup you were building this press for gunsmithing. Now it all makes more sense. Looking good.

Dan
Collecting tools for 30 years.
Reply
Thanks given by:


Messages In This Thread
new project - by dallen - 09-19-2012, 03:13 PM
RE: new project - by DaveH - 09-19-2012, 03:25 PM
RE: new project - by doubleboost - 09-19-2012, 03:32 PM
RE: new project - by Highpower - 09-19-2012, 04:49 PM
RE: new project - by dallen - 09-19-2012, 04:50 PM
RE: new project - by dallen - 09-19-2012, 04:59 PM
RE: new project - by stevec - 09-19-2012, 05:15 PM
RE: new project - by dallen - 09-19-2012, 05:28 PM
RE: new project - by stevec - 09-19-2012, 05:57 PM
RE: new project - by TomG - 09-19-2012, 06:26 PM
RE: new project - by dallen - 09-19-2012, 07:36 PM
RE: new project - by stevec - 09-20-2012, 07:28 AM
RE: new project - by dallen - 09-20-2012, 09:09 AM
RE: new project - by f350ca - 09-20-2012, 09:26 AM
RE: new project - by dallen - 09-20-2012, 11:28 AM
RE: new project - by stevec - 09-20-2012, 02:05 PM
RE: new project - by dallen - 09-24-2012, 02:39 PM
RE: new project - by stevec - 09-24-2012, 02:45 PM
RE: new project - by dallen - 09-24-2012, 07:08 PM
RE: new project - by dallen - 09-25-2012, 06:55 PM
RE: new project - by stevec - 09-25-2012, 06:59 PM
RE: new project - by EdK - 09-25-2012, 07:14 PM
RE: new project - by dallen - 09-25-2012, 07:21 PM
RE: new project - by dallen - 09-26-2012, 09:05 AM
RE: new project - by ETC57 - 09-26-2012, 11:00 AM
RE: new project - by dallen - 09-28-2012, 03:06 PM
RE: new project - by DanH - 09-28-2012, 04:09 PM



Users browsing this thread: 1 Guest(s)