09-27-2012, 08:38 PM
Rick,
I used Cadkey to plot the lines and to dimension the intersection. The 3.5" PCD measurement I stated is close but not accurate. This was used to test my theory only. So don't spend too much time on the math till I get more accurate measurements. I am off to Ottawa for the weekend so this project is definitely not going anywhere for a while.
Thanks for your help Claude
I used Cadkey to plot the lines and to dimension the intersection. The 3.5" PCD measurement I stated is close but not accurate. This was used to test my theory only. So don't spend too much time on the math till I get more accurate measurements. I am off to Ottawa for the weekend so this project is definitely not going anywhere for a while.
Thanks for your help Claude
claudef, proud to be a member of Metalworking Forum since Mar 2012.