MetalworkingFun Forum › Machining › General Metalworking Discussion v
Flat wrenches

Thread Modes
Flat wrenches
SnailPowered Offline
Junior
****
Posts: 258
Threads: 13
Joined: Aug 2012
Location: USA
#16
09-27-2012, 11:40 AM
I don't mean to use a nut for the wrench, I mean to have a hex shape where it would normally be rounded (you would have three flats on each side instead of a radius). Sorry, I guess I was clear as mud Rotfl
SnailPowered, proud to be a member of MetalworkingFun since Aug 2012.
Reply
Thanks given by:


Messages In This Thread
Flat wrenches - by Wawoodman - 09-26-2012, 09:11 AM
RE: Flat wrenches - by EdK - 09-26-2012, 09:54 AM
RE: Flat wrenches - by dallen - 09-26-2012, 10:16 AM
RE: Flat wrenches - by Wawoodman - 09-26-2012, 12:19 PM
RE: Flat wrenches - by EdK - 09-26-2012, 02:25 PM
RE: Flat wrenches - by dallen - 09-26-2012, 12:52 PM
RE: Flat wrenches - by Wawoodman - 09-26-2012, 03:26 PM
RE: Flat wrenches - by EdK - 09-26-2012, 05:26 PM
RE: Flat wrenches - by TomG - 09-26-2012, 09:30 PM
RE: Flat wrenches - by Wawoodman - 09-27-2012, 09:32 AM
RE: Flat wrenches - by TomG - 09-27-2012, 10:02 AM
RE: Flat wrenches - by stevec - 09-27-2012, 07:10 AM
RE: Flat wrenches - by EdK - 09-27-2012, 07:19 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 11:13 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:24 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 11:40 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:51 AM
RE: Flat wrenches - by dallen - 09-27-2012, 11:55 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:57 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 12:10 PM



Users browsing this thread: 5 Guest(s)