added some more weight to the press so it won't blow around when them Canadian winds blow thru.
Anyway guys over on the other forum were worried about things turning into arrow's with the base bowing a little so I added a 1/4 X 3 1/2 flat strap down each side with a spreader in the middle to keep them from wrinkling when some pressure is applied to it, skip welded them on so as not to bow the whole works
But first I did some work on this with it just to make sure it was still bowing up.
Anyway guys over on the other forum were worried about things turning into arrow's with the base bowing a little so I added a 1/4 X 3 1/2 flat strap down each side with a spreader in the middle to keep them from wrinkling when some pressure is applied to it, skip welded them on so as not to bow the whole works
But first I did some work on this with it just to make sure it was still bowing up.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!