|
new project
|
09-24-2012, 02:45 PM
(09-24-2012, 02:39 PM)dallen Wrote: the cylinder that my friend had gave to me was rusted pretty good, dallen, I'd say your cyl. was rusted "good" his was rusted "bad".  Whatever, I'm glad you're back to "pressing" issues.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
new project - by dallen - 09-19-2012, 03:13 PM
RE: new project - by DaveH - 09-19-2012, 03:25 PM
RE: new project - by doubleboost - 09-19-2012, 03:32 PM
RE: new project - by Highpower - 09-19-2012, 04:49 PM
RE: new project - by dallen - 09-19-2012, 04:50 PM
RE: new project - by dallen - 09-19-2012, 04:59 PM
RE: new project - by stevec - 09-19-2012, 05:15 PM
RE: new project - by dallen - 09-19-2012, 05:28 PM
RE: new project - by stevec - 09-19-2012, 05:57 PM
RE: new project - by TomG - 09-19-2012, 06:26 PM
RE: new project - by dallen - 09-19-2012, 07:36 PM
RE: new project - by stevec - 09-20-2012, 07:28 AM
RE: new project - by dallen - 09-20-2012, 09:09 AM
RE: new project - by f350ca - 09-20-2012, 09:26 AM
RE: new project - by dallen - 09-20-2012, 11:28 AM
RE: new project - by stevec - 09-20-2012, 02:05 PM
RE: new project - by dallen - 09-24-2012, 02:39 PM
RE: new project - by stevec - 09-24-2012, 02:45 PM
RE: new project - by dallen - 09-24-2012, 07:08 PM
RE: new project - by dallen - 09-25-2012, 06:55 PM
RE: new project - by stevec - 09-25-2012, 06:59 PM
RE: new project - by EdK - 09-25-2012, 07:14 PM
RE: new project - by dallen - 09-25-2012, 07:21 PM
RE: new project - by dallen - 09-26-2012, 09:05 AM
RE: new project - by ETC57 - 09-26-2012, 11:00 AM
RE: new project - by dallen - 09-28-2012, 03:06 PM
RE: new project - by DanH - 09-28-2012, 04:09 PM
|
