new project
#17
well I got out and about this morning and you guessed it, was lucky enough to find a gasket place that had the piston ring that I needed to repair the cylinder for 9.00 bucks plus the governors cut. So I got two of em and as my luck the barrel on the cylinder that my friend had gave to me was rusted pretty good, lucky again in that the one I started with had some pits but they cleaned up with a hone.

So now I'm back in the press business soon as I get my mill back to running so I can make some attachments to press stuff against.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
new project - by dallen - 09-19-2012, 03:13 PM
RE: new project - by DaveH - 09-19-2012, 03:25 PM
RE: new project - by doubleboost - 09-19-2012, 03:32 PM
RE: new project - by Highpower - 09-19-2012, 04:49 PM
RE: new project - by dallen - 09-19-2012, 04:50 PM
RE: new project - by dallen - 09-19-2012, 04:59 PM
RE: new project - by stevec - 09-19-2012, 05:15 PM
RE: new project - by dallen - 09-19-2012, 05:28 PM
RE: new project - by stevec - 09-19-2012, 05:57 PM
RE: new project - by TomG - 09-19-2012, 06:26 PM
RE: new project - by dallen - 09-19-2012, 07:36 PM
RE: new project - by stevec - 09-20-2012, 07:28 AM
RE: new project - by dallen - 09-20-2012, 09:09 AM
RE: new project - by f350ca - 09-20-2012, 09:26 AM
RE: new project - by dallen - 09-20-2012, 11:28 AM
RE: new project - by stevec - 09-20-2012, 02:05 PM
RE: new project - by dallen - 09-24-2012, 02:39 PM
RE: new project - by stevec - 09-24-2012, 02:45 PM
RE: new project - by dallen - 09-24-2012, 07:08 PM
RE: new project - by dallen - 09-25-2012, 06:55 PM
RE: new project - by stevec - 09-25-2012, 06:59 PM
RE: new project - by EdK - 09-25-2012, 07:14 PM
RE: new project - by dallen - 09-25-2012, 07:21 PM
RE: new project - by dallen - 09-26-2012, 09:05 AM
RE: new project - by ETC57 - 09-26-2012, 11:00 AM
RE: new project - by dallen - 09-28-2012, 03:06 PM
RE: new project - by DanH - 09-28-2012, 04:09 PM



Users browsing this thread: 2 Guest(s)