MetalworkingFun Forum › Machinery › Lathes v
Leveling?

Thread Modes
Leveling?
Wongster Offline
Junior
****
Posts: 301
Threads: 30
Joined: Mar 2012
Location: Singapore
#17
09-24-2012, 11:33 AM
Hello Rick,

I've yet to bolt the lathe down. Just did another shifting of machines around.

I asked my friend, who is a renovation contractor about granite and korian top. He told me that these can chip and crack easily. True? I've no experience in these.

Regards,
Wong
Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.
Reply
Thanks given by:


Messages In This Thread
Leveling? - by Wongster - 04-08-2012, 10:02 AM
RE: Leveling? - by aametalmaster - 04-08-2012, 10:17 AM
RE: Leveling? - by DaveH - 04-08-2012, 10:57 AM
RE: Leveling? - by Wongster - 04-08-2012, 11:12 AM
RE: Leveling? - by DaveH - 04-08-2012, 11:16 AM
RE: Leveling? - by DaveH - 04-08-2012, 11:29 AM
RE: Leveling? - by Bogstandard - 04-08-2012, 12:05 PM
RE: Leveling? - by DaveH - 04-08-2012, 12:36 PM
RE: Leveling? - by Wongster - 04-08-2012, 01:24 PM
RE: Leveling? - by DaveH - 04-08-2012, 02:04 PM
RE: Leveling? - by Wongster - 04-08-2012, 06:25 PM
RE: Leveling? - by DaveH - 04-08-2012, 07:04 PM
RE: Leveling? - by Wongster - 04-08-2012, 07:32 PM
RE: Leveling? - by DaveH - 04-08-2012, 07:57 PM
RE: Leveling? - by Rickabilly - 09-23-2012, 10:12 AM
RE: Leveling? - by Hopefuldave - 09-23-2012, 06:00 PM
RE: Leveling? - by Wongster - 09-24-2012, 11:33 AM
RE: Leveling? - by Rickabilly - 09-24-2012, 01:12 PM
RE: Leveling? - by stevec - 09-24-2012, 02:56 PM
RE: Leveling? - by Wongster - 09-24-2012, 05:38 PM
RE: Leveling? - by Rickabilly - 09-25-2012, 04:29 AM
RE: Leveling? - by stevec - 09-24-2012, 05:42 PM



Users browsing this thread: 2 Guest(s)