Let's See Your Mill

[EdK]

(09-23-2012, 08:53 AM)Rickabilly Wrote: I've got to admit I'm no fan of horizontal adaptors, I mean, yes they do let you use horizontal cutters but are just no where near rigid enough to actually use them properly, the real beauty of a horizontal mill is that the spindle is embedded in the column for the ultimate in rigidity,

I prefer the frankenmill route of fitting a vertical milling head to a horizontal mill, But I will check out the elliot,

Thanks for the tip

Rick,

That was my concern also with the adapters. What is a "frankenmill"?

Thanks,
Ed