MetalworkingFun Forum › Machining › General Metalworking Discussion v
DRO repair

Thread Modes
DRO repair
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#7
09-22-2012, 07:14 AM (This post was last modified: 09-22-2012, 07:14 AM by stevec.)
Pix, that reader head sure looks like the ones on my DRO, especially the little bearing rollers, connecting rod and enclosure.
150mm is just shy of 6" so it's too short for me.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
DRO repair - by stevec - 09-21-2012, 02:01 PM
RE: DRO repair - by doubleboost - 09-21-2012, 03:21 PM
RE: DRO repair - by EdK - 09-21-2012, 03:41 PM
RE: DRO repair - by stevec - 09-21-2012, 05:48 PM
RE: DRO repair - by f350ca - 09-21-2012, 06:47 PM
RE: DRO repair - by PixMan - 09-21-2012, 07:10 PM
RE: DRO repair - by stevec - 09-22-2012, 07:14 AM
RE: DRO repair - by claudef - 09-23-2012, 05:48 AM
RE: DRO repair - by stevec - 09-23-2012, 07:58 AM



Users browsing this thread: 3 Guest(s)