MetalworkingFun Forum › Machining › General Metalworking Discussion v
Small V blocks - an aid to work holding

Thread Modes
Small V blocks - an aid to work holding
EdK Offline
Whipping Boy
*******
Posts: 8,846
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
#8
09-19-2012, 05:02 PM
(09-19-2012, 04:24 PM)TomG Wrote: One caveat to be aware of; the jaws on most vises are held on by a couple of cap screws and can float around. Make sure yours are parallel to the bottom of the vise before locating off the top of them.

Tom

Excellent tip Tom! 6799

Ed
Reply
Thanks given by:


Messages In This Thread
RE: Small V blocks - an aid to work holding - by EdK - 09-19-2012, 05:02 PM
RE: Small V blocks - an aid to work holding - by Wawoodman - 09-19-2012, 08:43 PM



Users browsing this thread: 9 Guest(s)