Cheap Chinese Motor

[EdK]

(09-18-2012, 04:00 PM)dallen Wrote:

(09-18-2012, 03:41 PM)EdK Wrote: I have the original motor from my Enco RF-45 clone that you're welcome to but shipping will be a killer.

Ed

what size is the shaft on your single phase motor Ed, I know that the mills are almost identical, shipping will be cheaper then a new motor,

sucks it won't fit in a flat rate box, I received an 8 inch bison lathe chuck that way once had to go to the post office to get it

but I guess that depends on what you would want for your motor.

DA,

The shaft is 19mm.

Ed