(09-18-2012, 03:41 PM)EdK Wrote: I have the original motor from my Enco RF-45 clone that you're welcome to but shipping will be a killer.
Ed
what size is the shaft on your single phase motor Ed, I know that the mills are almost identical, shipping will be cheaper then a new motor,
sucks it won't fit in a flat rate box, I received an 8 inch bison lathe chuck that way once had to go to the post office to get it
but I guess that depends on what you would want for your motor.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!